TBUS-1Axl - Installing the TBUS-1Axl
15
15
5.3
Cutting an Opening in the Table
To cut an opening in the table:
1. Place the included cut out template (that is included with your
TBUS-1Axl
)
on the surface of the table exactly where you want to install the
TBUS-1Axl
.
2. Attach the template to the table with the included screws (if using the cut out
template).
3. Following the
inside
edge of the template, cut a hole in the table surface
with a sabre or keyhole saw according to the dimensions shown in
(not to scale).
i
The thickness of the table should be 76.2 mm / 3 inches or less.
Figure 8: Cut out Dimensions
4. Unscrew and remove the template from the surface of the table and clean
the table surface.
Take care not to damage the table.
If needed, you can download a full-scale template from our Web site.
!
Kramer Electronics is not responsible for any damage caused to the
table.
