PT-110xl, WP-110, PT-120xl, TP-120 - PT-110xl UXGA Line Transmitter
5
3.2
Connecting the PT-110xl UXGA Line Transmitter
To connect the
PT-110xl
(as shown in
Figure 2
) do the following:
1. Connect a UXGA source (for example, a computer graphics card) to the
15-pin HD UXGA INPUT connector.
2. Connect a CAT5/6 cable to the RJ-45 LINE OUT connector.
Figure 2: Connecting the PT-110xl UXGA Line Transmitter
3.3
Capturing the EDID
To capture an EDID:
Connect the device from which you want to capture the EDID (for example, a
display, switcher, DA, etc.) directly to the UXGA input of the
PT-110xl
Press the EDID capture button.
The EDID status LED flashes slowly several times. The new EDID is
captured when the LED stops flashing and lights solid.
Note
: If the status LED flashes quickly for a few seconds and then stays on
solid, the
PT-110xl
could not capture the EDID and loaded the default EDID
instead.
