Connecting the WP-561/WP-562 Transmitter/Receiver Pair
11
5
Connecting the WP-561/WP-562 Transmitter/Receiver Pair
To install the
WP-561
HDMI Line Transmitter
:
1. Connect the CAT 5 cable 1 RJ-45 connector to the OUT 1 RJ-45 socket
1
.
2. Connect the CAT 5 cable 2 RJ-45 connector to the OUT 2 RJ-45 socket
1
.
3. Connect the 5V DC power to the terminal block pins
2
, taking care that the
polarity is correct
.
4. Insert
the
WP-561
directly into the wall box opening, and then mount the
front panel securely using the screws.
5. Connect the HDMI source to the
HDMI IN
connector.
6. If required, connect an IR receiver or emitter to the 3.5mm mini jack
3
To install the
WP-562
HDMI Line Receiver
:
1. Connect the CAT 5 cable 1 RJ-45 connector to the IN 1 RJ-45 socket
1
.
2. Connect the CAT 5 cable 2 RJ-45 connector to the IN 2 RJ-45 socket
1
.
3. Insert
the
WP-562
directly into the wall box opening, and then mount the
front panel securely using the screws.
4. Connect the HDMI acceptor to the
HDMI OUT
connector.
5. If required, connect an IR emitter or receiver to the 3.5mm mini jack
3
.
1 See section
7.1
2 Connect the wire labeled “+” to the +5V pin, and the wire labeled “–” to the GND pin
3 See section
7.2
