Overview
3
3 Overview
The
TP-573
and
TP-574
are a twisted pair transmitter and receiver for
HDMI, bidirectional RS-232 and infrared signals. The
TP-573
converts the
input signals to a twisted pair signal and the
TP-574
converts it back to
HDMI, RS-232 and infrared signals.
Using the
TP-573
and
TP-574
, you can pass via the twisted pair cable:
x
EDID (Extended Display Information Data) and HDCP signals
between the
TP-573
and
TP-574
, and vice versa between the
TP-574
and
TP-573
x
HPD (Hot Plug Detect) signals from the display device to the source
The transmitter / receiver pair feature:
x
A maximum data rate of 1.65Gbps
x
Bidirectional RS-232 and IR interfaces. The IR input/output transmits
and receives IR commands over CAT 5 cable
1
x
An RS-232 baud rate of up to 38400kbps
x
HDTV compatibility
x
A system range
2
of up to 90m (295ft) at 1080i, or up to 30m (98ft) at
1080p on shielded
BC-DGKat524
cable; 90m (295ft) at 1080i, or up to
70m (230ft) at 1080p on shielded
BC-DGKat623
cable; 100m (330ft) at
1080i or up to 90m (295ft) at 1080p on shielded
BC-DGKat7a23
cable.
Note, use only shielded cables with the
TP-573 / TP-574
, in which the
cable Ground shielding must be connected / soldered to the shield of
both RJ-45 connectors
x
Power save, the
TP-573 / TP-574
system goes into standby mode when
the HDMI input is not connected
x
The Power Connect System™ – a single connection to the transmitter
powers both units
x
A compact DigiTOOLS
®
enclosure where three units can be rack mounted
side-by-side in a 1U rack space with the optional
RK-3T
rack adapter
1 Compatible with a Kramer transmitter and via a Kramer external remote receiver: C-A35M/IRR or C-A35M/IRE or
C-A35M/2IRE
2 Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non-
Kramer CAT 5, CAT 6 and CAT 7a cables may not reach these ranges
