Kramer Electronics Ltd.
PT-871/2-KIT, PT-871/2xr-KIT, WP-871xr, WP-872xr, PT-871xr, PT-872xr
– Installing Device
7
Installing Device
This section provides instructions for installing
PT-871/2-KIT, PT-871/2xr-KIT, WP-871xr,
WP-872xr, PT-871xr, PT-872xr
.
Before installing the device, verify that the environment is within the recommended range:
•
Operation temperature
– 0
to 40
C (32 to 104
F).
•
Storage temperature
– -40
to +70
C (-40 to +158
F).
•
Humidity
– 10% to 90%, RHL non-condensing.
When installing on a 19" rack, avoid hazards by taking care that:
•
It is located within recommended environmental conditions. Operating
ambient temperature of a closed or multi-unit rack assembly may exceed
ambient room temperature.
•
There is enough air flow around the device.
•
The device is placed upright in the correct horizontal position.
To mount PT-871/2-KIT, PT-871/2xr-KIT, PT-871xr and PT-872xr:
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/downloads/PT-871/2-KIT
•
Fasten a bracket (included) on each side of the unit and attach it
to a flat surface.
For more information go to
www.kramerav.com/downloads/PT-871/2-KIT
•
Attach the rubber feet and place the unit on a flat surface.
