Your SP-11D Digital Video Processor
7
#
Feature
Function
25
V/RED
Button
Press the V
4
/RED
5
button
6
and adjust using the + and – buttons
26
YUV/RGB
LEDs
Cycle between the different color spaces of color control: YUV and
RGB. The corresponding LED lights
27
COLOR SPACE
Button
Press to select the color space of the color control; if the COLOR
SPACE button is not illuminated, color control is disabled
28
STORE
Button
Stores the current setup in the non-volatile memory
29
RECALL
Button
Recalls a setup from the non-volatile memory
30 7-segment
Display
Displays data when using a front panel button
31 - Button
Press to decrease the level
32 + Button
Press to increase the level
33
FREEZE
Button
Pauses the output video
34
PANEL LOCK
Button
Disengages the front panel buttons
Table 2: Rear Panel SP-11D Digital Video Processor
#
Feature
Function
35
INP
UT
S
CV
BNC Connector
Connects to the composite video source
36
Y/C
4-pin Connector
Connects to the s-Video source
37
G/Y
BNC Connector
Connects to the RGB (connect all 3 connectors:
G, B, and R), or YUV (connect all 3 connectors:
Y, B-Y, and R-Y), or RGBS (connect all 4
connectors: G, B, R and S
2
38
) video source
R/R-Y
BNC Connector
39
B/B-Y BNC
Connector
40
SYNC
BNC Connector
Connects to the external video sync source
41
SDI
BNC Connector
Connects to the SDI source
42
O
U
TP
U
TS
SPLITTER
BNC Connector
Connects to the split image acceptor
43
Y/C
4-pin Connector
Connects to the s-Video (Y/C) acceptor
44
CV
BNC Connector
Connects to the composite video acceptor
45
G/Y
BNC Connector
Connects to the RGB (connect all 3 connectors:
G, B, and R), or YUV (connect all 3 connectors:
Y, B-Y, and R-Y), or RGBS (connect all 4
connectors: G, B, R and any Cs), or RGBHV
(connect all 5 connectors: G, B, R, Hs and Vs)
video acceptor
46
R/R-Y
BNC Connector
47
B/B-Y
BNC Connector
48
Vs
(vertical sync)
/Cs
3
49
BNC Connector
Hs
(horizontal sync)
/Cs
3
BNC Connector
50
SDI
BNC Connector
Connects to the serial digital video acceptor 1
51
SDI
BNC Connector
Connects to the serial digital video acceptor 2
52
LOOP
BNC Connector
Connects to the next Genlocked unit
53
SYNC
BNC Connector
Connects to the Genlock source
54
75 OHMS IN
Button
Press to terminate the Genlock source (75
Ω
) or
release for looping
4
55
RS-232
Port
Connects to the PC or the Remote Controller
56
SETUP
DIP-switches
DIP-switches setup (see section
6.2
)
57 Power Connector with Fuse
AC connector enabling power supply to the unit
1 Available in all input and output formats and standards
2 Item 6 below
3 To use Cs (Composite Sync), set Dipswitch 2 ON (see
Table 3
for details)
4 Push in to terminate the input. Release when the input extends to another unit
