Installing the Inner Frame
To install the
T10F-22M
inner frame:
1. Place the assembled inner frame inside the
TBUS-10XL
enclosure.
2. Set the required height using your fingers to bring the inner frame to the desired position,
and then screw and tighten it in place using the height adjustment screws supplied with the
inner frame.
Connecting the Cables
When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so on):
1. Insert the cables to their appropriate connectors from underneath.
2. Secure the cables to the tie holes on the
TBUS-10XL
.
Do not secure the cables too tightly or too loosely. Leave a small amount of slack.
After the
TBUS-10XL
is connected to mains power and the proper cables, it is ready for use.
Adjusting the Height of the Inner Frame
If needed, you can adjust the inner frame to one of the several possible heights to accommodate
large or bulky cables. To adjust, perform the following:
1. Remove the height adjustment screws, while supporting the frame from underneath with
your fingers.
2. Raise or lower the connecting surface to the required height, insert the screws, and tighten
them in place.
K R AM E R E LE CT R O N IC S L T D .
Installation
Instructions
MODEL:
T10F-22M
Inner Frame
For the latest information on our products and a list of Kramer
distributors, visit our Web site where updates to this user manual may be
found.
We welcome your questions, comments, and feedback.
Web site:
E-mail:
P/N: 2900-300225 Rev 2
P/N:
2900- 300225
Rev:
2
!
SAFE TY WARNI NG
Disconnect the unit from the power
supply before opening and servicing