TP-46N - Connecting a Component/UXGA/Audio Distribution System
9
5. Connect the LINE OUTPUT RJ-45 connector on the
TP-45
to the
LINE IN RJ-45
connector on the
TP-46N
, via CAT 5 cabling, see
Section
4.3
.
6. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on both the
TP-45
and the
TP-46N
(not
shown in
Figure 2
).
The signal from the UXGA source is transmitted via CAT 5 cable, decoded
and converted at the UXGA OUT 15-pin HD (F) connector to the UXGA
acceptor.
If you cannot connect the power to both the
TP-45
and
TP-46N
, you can connect the
power to the
TP-46N
alone (see
Section
3.1
).
7. If required, connect the LINE OUT RJ-45 connector on the
TP-46N
to an
additional
TP-46N
.
Figure 2: Distribution System, UXGA Mode
