Overview
3
3
3 Overview
The Kramer
TP-551HDCP
and
TP-552HDCP
constitute a high quality DVI
line transmitter / receiver system using two STP cables.
This transmitter / receiver pair features:
•
System Range
1
•
Cables – For optimum range and performance, use Kramer's
BC-DGKat524
,
BC-DGKat623
and
BC-DGKat7a23
- Up to 60m (197ft) at XGA, or up to 30m (98ft) at
WUXGA on shielded
BC-DGKat524
cable; 60m (197ft) at SXGA on
shielded
BC-DGKat623
cable; 60m (197ft) at SXGA on shielded
BC-DGKat7a23
cable
•
Support for up to 1.65Gbps bandwidth
•
The passing of the EDID and HPD
2
•
Support for the DDWG DVI 1.0 standard
signals from the source to the display
device using the cables
Note that only the digital signal (DVI-D) is available on the DVI connector
.
The
TP-551HDCP
DVI Line Transmitter
features:
•
A DVI input and a pair of RJ-45 CAT 5 output connectors
•
Three status LEDs (INPUT, OUTPUT and POWER)
The
TP-552HDCP
DVI Line Receiver
features:
•
A DVI output and a pair of RJ-45 CAT 5 input connectors
•
Three status LEDs (INPUT, OUTPUT and POWER)
•
EQ. adjustment to enhance performance
3.1 Recommendations for Achieving the Best Performance
To achieve the best performance:
•
Connect only good quality connection STP CAT 5e 24AWG
or STP
CAT 6 cables, thus avoiding interference, deterioration in signal quality
due to poor matching, and elevated noise-levels (often associated with low
quality cables)
•
Avoid interference from neighboring electrical appliances and position your
TP-551HDCP
/
TP-552HDCP
away from moisture, excessive sunlight and
dust
1 Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non-
Kramer CAT 5, CAT 6 and CAT 7a cables may not reach these ranges
2 Hot Plug Detect
