8
TP-780TXR/TP-780RXR - Connecting the TP-780TXR and TP-780RXR
4
Connecting the TP-780TXR and TP-780RXR
Always switch off the power to each device before connecting it to your
Transmitter and Receiver. After connecting your Transmitter and
Receiver, connect their power and then switch on the power to each
device.
You can use the
TP-780TXR
and
TP-780RXR
Extended Range
HDMI Line
Transmitter
/
Re POE
to configure an HDMI transmitter/receiver system, as
shown in the example in
Figure 3
.
To connect the
TP-780TXR
, connect the:
1. HDMI source (for example, a DVD player) to the HDMI IN connector.
2. RS-232 9-pin D-sub connector to a computer (for example, a laptop to
control the projector).
3. IR 3.5mm mini jack to an IR emitter.
4. HDBT OUT RJ-45 connector over twisted pair to the
HDBT IN
connector.
Alternatively, you can use any other certified HDBaseT receiver device (for example,
the Kramer
WP-580R
)
5. 48V DC power adapter to the power socket and connect the adapter to the
mains electricity (not shown in Figure 3).
To connect the
TP-780RXR
, connect the:
1. HDMI OUT connector to the HDMI acceptor (for example, a projector).
2. RS-232 9-pin D-sub connector to an RS-232 port (for example, a projector that is
controlled by the laptop connected to
TP-780TXR
).
3. IR 3.5mm mini jack to an IR sensor.
4. HDBT IN RJ-45 connector over twisted pair to the
TP-780TXR HDBT OUT
connector.
Alternatively, you can use any other certified HDBaseT transmitter device (for example,
the Kramer
WP-580T
)
5. If operating the
TP-780RXR
over a range of more than 100m (328ft),
connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in
Figure 3
).
!
