8
VM-4DP - Connecting the VM-4DP
5
Connecting the VM-4DP
Always switch off the power to each device before connecting it to your
VM-4DP
. After connecting your
VM-4DP
, connect its power and then
switch on the power to each device.
To connect the
VM-4DP
as illustrated in the example in
Figure 3
:
1. Connect a DP source (for example, a computer graphics source) to the DP
INPUT connector.
2. Connect the DP output connectors (not all the outputs need to be
connected), to up to four DP acceptors (for example, displays).
3. Connect the power cord to the mains electricity (not shown in
Figure 3
).
4. Turn ON the POWER on the rear panel.
5. Acquire the EDID, see
Section
6
.
Figure 3: Connecting the VM-4DP
1:4 DisplayPort Distributor
i
Summary of Contents for VM-4DP
Page 2: ......
