Kramer Electronics Ltd.
VP-427X2
– Using Embedded Web Pages
25
3. If required, enter a new name, and click the save icon to change the name of the input
that appears in the web pages.
4. Click
ON
/
OFF
to enable/disable the HDCP decryption on the selected input.
If HDCP is disabled on an input, an HDCP encrypted source will not pass through the unit.
Inputs are configured.
Selecting an Input
To select an input to be switched to the output using the web pages:
1. Click
Input Select
on the Navigation List.
The Input Select page appears (
2. In the Video Switching area, click the required input button.
The input button turns green
The selected input is switched to the output.
Freezing or Blanking the Video Output Signal
To freeze or clear the video output, do one of the following:
1. Click
Input Select
on the Navigation List.
The Input Select page appears (
2. In the Video Switching area, click one of the following:
▪
– Freezes the currently displayed video frame.
To define what happens when you press the Freeze button,
see
Defining FREEZE Button Operation Mode
▪
– Blanks the video output from the display; the display goes blank.
Output video signal is frozen/blanked.
Adjusting the Output Volume
The analog audio output volume can also be adjusted from the Audio web page.
To adjust the output volume:
1. Click
Input Select
on the Navigation List.
The Input Select page appears (
2. Use the slider controls in the Volume area of the web page to change the volume or
enter the value in the text box above the slider.
3. Click
to mute the output.
Audio output volume is adjusted.
