Kramer Electronics Ltd.
VP-444
– Operating VP-444
13
Mode
Function
When FOLLOW INPUT is selected, it changes its HDCP output setting (for
the HDMI output) according to the HDCP of the input. This option is
recommended when the HDMI output is connected to a splitter/switcher
When FOLLOW OUTPUT is selected, the scaler matches its HDCP output
to the HDCP setting of the HDMI acceptor to which it is connected
AUTO SYNC
OFF
Turn to DISABLE (default), FAST (for almost immediate shut down if no
input is present
– about 10 seconds) or SLOW (for shutdown after about 2
minutes).
This is useful, for example, when the output is connected to a projector, and
the projector will automatically shut down when it has no input
OSD
H POSITION
Set the horizontal position of the OSD
V POSITION
Set the vertical position of the OSD
TIMER
Set the timeout period in seconds
TRANSPARENCY
Set the OSD background between 100 (transparent)
and 0 (opaque)
DISPLAY
Select the information shown on the screen during
operation:
INFO (default): the information is shown for 10
seconds
ON: the information is shown permanently
OFF: the information is not shown
MUTE
FOLLOWS
FREEZE
Set to ON (default) to have MUTE follow FREEZE. Otherwise set to OFF
MUTE BUTTON
DEFINE:
Define the MUTE button to function as MUTE, BLANK or BLANK AND
MUTE
AUTO
SWITCHING
MODE
Set the auto switching mode to OFF, AUTO SCAN
(default) or LAST CONNECTED. PRIORITY (below)
is enabled when AUTO SCAN is selected
When one of the auto switching modes is selected
(AUTO SCAN or LAST CONNECTED), audio is
enabled only when a video signal is detected
SCAN PRIORITY
Set to HDMI (default) to begin scan with HDMI1 or to
PC to begin scan with PC1
ETHERNET
IP MODE
Set the IP mode to DHCP or STATIC IP
STATIC IP ADDRESS (fill in if STATIC IP (above) is selected:
IP ADDRESS
Enter the IP address (192.168.1.39)
SUBNET
Enter the subnet (255.255.0.0)
GATEWAY
Enter the gateway (0.0.0.0)
CONTROL PORT
Enter the control port
MAC ADDRESS
MAC address
LOCK MODE
ALL
Lock all the front panel buttons
MENU ONLY
Lock the MENU (and navigation) front panel buttons
only
ALL & SAVE
Lock all the front panel buttons.
The lock status is saved when the
VP-444
is
powered down
MENU ONLY &
SAVE
Lock the MENU (and navigation) front panel buttons
only.
The lock status is saved when the
VP-444
is
powered down
TIMING SHIFT
Set to ON (recommended):
Implements a small shift on the horizontal sync to improve output picture
stability. Set to OFF if the display shows an instability at the selected output
resolution
FACTORY RESET