VP-553xl –
Controlling the VP-553xl
17
6.2
Using the OSD Menu
The control buttons let you control the
VP-553xl
via the OSD menu. Press the:
•
MENU button to enter the menu
The default timeout is set to 10 seconds
•
ENTER button to accept changes and to change the menu settings
•
Arrow buttons to move through the OSD menu, which is displayed on the
video output
On the OSD menu, select EXIT to exit the menu.
6.2.1
The MAIN Menu
Mode
Function
OUTPUT 1
Set the output 1 parameters, see
Section 6.2.2
OUTPUT 2
Set the output 2 parameters, see
Section 6.2.3
AUDIO OUT
Set the audio output parameters, see
Section 6.2.4
AUDIO SET
Set the audio input parameters, see
Section 0
USB
Set the USB ports behavior, see
Section 6.2.6
OSD
Set the OSD parameters: H POSITION, V POSITION, TIMER, BACKGROUND
and DISPLAY, see
Section 6.2.7
FACTORY
Select YES to reset to the default parameters.
If you cannot see the display after factory reset, use the front panel RESET TO
XGA/720p
button to set the correct resolution: press to toggle between reset to
XGA and reset to 720p
ETHER(NET)
IP MODE
: Set to DHCP or STATIC. When selecting STATIC IP, the IP number
appears next to IP ADDRESS
SET STATIC IP
: set the IP ADDRESS, DEF. GATEWAY (default gateway), and
SUBNET MASK.
CONTROL PORT
: set the CONTROL PORT number
MISC.
You can use a remote control transmitter (that is used for controlling a
peripheral device, for example, a DVD player) to send commands (to the
A/V equipment) from/to any of the transmitters /receiver connected to the
HDBT connectors.
Select the IR transmission route for each of the units that are connected to the
HDBT connectors (IN+OUT):
HDBT1 (IR OUT)
: set to HDBT2, HDBT3 or HDBT OUT (to set the IR route
from/to HDBT2, HDBT3 or HDBT OUT to HDBT1)
HDBT2 (IR OUT)
: set to HDBT1, HDBT3 or HDBT OUT (to set the IR route
from/to HDBT1, HDBT3 or HDBT OUT to HDBT2)
HDBT3 (IR OUT)
: set to HDBT1, HDBT2 or HDBT OUT (to set the IR route
from/to HDBT1, HDBT2 or HDBT OUT to HDBT3)
HDBT OUT (IR OUT)
: set to HDBT1, HDBT2 or HDBT3 (to set the IR route
from/to HDBT1, HDBT2 or HDBT3 to HDBT OUT)
For example, set HDBT1 (IR OUT) to HDBT2 to control (via IR) the peripheral
device that is connected to the device connected to HDBT 1 via the device
connected to HDBT2, see
