VS-1616D - Connecting the VS-1616D
13
5
Connecting the VS-1616D
Always switch off the power to each device before connecting it to
your
VS-1616D
. After connecting your
VS-1616D
, connect its power
and then switch on the power to each device.
You do not have to connect all the inputs and outputs, connect only
those that are required. In the following example, only two inputs and
two outputs are connected.
The configuration of DVI input/output cards shown in
is merely a sample
representation and different input / output cards may be mixed as required (for
limitations, see
Section 5.1
). Exactly the same principles apply to installations using
other card types.
To connect the
VS-1616D
, as illustrated in the example in
, do the
following:
1. Connect up to 16 DVI video sources (for example, computer graphics
sources).
2. Connect up to 16 DVI video acceptors, (for example, a plasma display and a
DVI LCD display).
3. If required, connect a PC or remote controller to the RS-232 port (see
Section 5.2
) and/or the Ethernet port (see
Section 5.3
4. Connect the power cord.
5. If necessary, review and set the system configuration using the Menu
(see
Section 7
Given an input signal that is HDCP encoded, the
VS-1616D
outputs
a signal only if the output port to which it is switched supports HDCP.
