VS-1616D - Operating Your Video Matrix Switcher
23
6.3
Confirming Actions
You can choose to work in the At Once (default, for all actions except
storing/recalling) or the Confirm mode.
In the At Once mode:
•
The TAKE button does not light
•
Pressing an
OUT-IN combination implements the switch without further user
confirmation
•
You save time as execution is immediate and actions require no user
confirmation
•
No protection is offered to correct an erroneous action
•
In the Confirm mode:
•
The TAKE button lights
•
You enter an action and then confirm it by pressing the TAKE button
•
Every action requires user confirmation, protecting against erroneous actions
•
Execution is postponed until you confirm the action
Failure to press the TAKE button within a few seconds results in the
action timing out automatically.
6.3.1
Toggling between the At Once and Confirm Modes
To toggle between the At Once and Confirm modes:
If the TAKE button is flashing you cannot toggle between the At Once
and Confirm modes. A flashing TAKE button indicates that an action
is currently pending confirmation.
1. Press TAKE to toggle between the At Once mode and the Confirm mode.
The TAKE button lights and actions now require user confirmation.
2. Press the lit TAKE button to toggle from the Confirm mode back to the At
Once mode.
The TAKE button is no longer lit and actions no longer require user
confirmation.
