26
VS-1616D - Operating Your Video Matrix Switcher
To turn an output off:
1. Press MENU.
The Menu buttons light and are enabled.
2. Press OFF (3) on the numeric keypad (see
).
The following message is displayed:
out__ => OFF
3. Use the numeric keypad to turn the required output off.
The output is turned off.
To turn an output off in the Confirm mode:
•
Repeat the steps above and then press the flashing TAKE button to confirm
the action.
Alternatively, you can perform a switching operation (see
Section 6.4.1
) and set the
input to 00.
6.4.4
Turning Off Several Outputs
To turn off several outputs in the Confirm mode, repeat the switching actions
described in
Section 6.4.2
6.4.5
Recalling the Default Setup
You can store a commonly used setup as the default setup (see
Section 7.2.8
which can be recalled at any time.
This is not the setup that is loaded when the unit is turned on. When
the unit is turned on, the setup that was last used before the unit was
turned off is loaded.
To recall the default setup:
1. Press DEFAULT SETUP.
The DEFAULT SETUP button flashes and the following message is
displayed:
recall DEFAULT setup
press FLASHING button to confirm
