VS-1616D - Using the Configuration Menus
39
5. Press TAKE to enter the parameters list.
A message similar to the following is displayed with the relevant port number
in place of 06:
OUT: 06
SET: Reset SubBoard
6. To select the next parameter press the right arrow button. (See the table at
the end of this section for available parameters.)
Or:
7. To enter the displayed parameter press TAKE.
The parameter options are displayed.
8. Select the required action or number using the keypad numbers and arrows.
9. Press TAKE to save the change.
The parameter change is not implemented on the system until you
press TAKE.
10. Repeat from Step 6 to modify other parameters
11. Do one of the following:
•
Press BREAKAWAY to exit the Config Menu
•
Wait approximately 15 seconds for the operation to time out
•
Press MENU to exit to the parameter list
7.2.5
Config Menu—Interface Configuration
This option lets you activate or deactivate the IR (infrared) and Ethernet interfaces.
To activate or deactivate the IR or Ethernet interfaces:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
