KRAMER: SIMPLE CREATIVE TECHNOLOGY
MENU Commands Sequence
40
8.8 Setting the IR REMOTE Control
Set the IR REMOTE control to enable remote control of the
16x16 Audio-
Video Matrix Switcher
, using the
Kramer
Infra-Red Remote Control Device
1
.
Refer to the
Infra-Red Remote Control Device
user manual
2
Table 6
, for full details.
and Table 7 summarize the setup and operational commands.
Table 6: Summary of Basic IR-1 Setups
To execute this command: Press the following keys in this sequence:
Allocate the unit to Group 12 SHIFT + GROUP + 12
Set the MACHINE #
UNIT + # key
3
To enable IR REMOTE control (when set OFF), do the following:
(according to the unit dipswitch settings)
1. Press the MENU button until reaching the IR REMOTE setting.
The MATRIX Display shows the message:
IR REMOTE setting
yes -> TAKE, next -> MENU
2. Press the
TAKE
button.
The Displays show the messages:
Outkey 1: InfraredREMOTE OFF
2: InfraredREMOTE ON
current:
remote OFF
3. Press the
OUT
button
2
.
The TAKE LED blinks and the Displays show the messages:
Turn ON infrared REMOTE ?
Press TAKE to execute
Current:
remote OFF
4. Press the
TAKE
button again.
The Displays show the messages:
Infrared REMOTE mode
changed
Current:
remote ON
Table 7: Summary of Basic IR-1 Operations
To execute this command:
Press the following keys in this sequence:
Switch an Input to an Output
# key (for the output) + # key (for the input)
4
Store/Recall a setup
SHIFT + STO/RCL + # key (for the setup)
1 After enabling the IR REMOTE control command, remotely control the unit via the IR-1 remote control transmitter pointed
at the remote receiver on the machine’s front panel (item 1 in Figure 2)
2 You can download the user manual: RC-IR1, IR-1, IR-1-01, from the Internet at http://www.kramerelectronics.com
3 For example, press UNIT + # 1 if the unit is set as MACHINE # 1
4 For example, press # 6 followed by # 2 to switch input 2 to output 6
Summary of Contents for VS-162AV
Page 52: ......
