KRAMER: SIMPLE CREATIVE TECHNOLOGY
MENU Commands
48
7. Press the
TAKE
button again.
The displays show the messages:
MACHINE ADDRESS
changed
current #
x
After a few seconds, The displays show the messages:
SET highest MACHINE ADDRESS
use OUTkey 1-9, 0
current #
x
8. Press an
OUT
button
#
1-9, 0
.
The STATUS Display shows the message:
current:
x
Where x is the OUT button # pressed
9. Press the
TAKE
button again.
The MATRIX display shows the message:
Change highest MACH. ADDR. ?
Press TAKE to confirm
10. Press the
TAKE
button again.
The MATRIX display shows the message:
HIGHEST MACHINE ADDRESS
Changed
11.5 Choosing the SWITCHING METHOD Setting
Section
11.5.1
describes the SWITCHING METHOD settings for
standalone units and large matrices. Section
11.5.2
describes how to
configure a SWITCHING METHOD.
11.5.1 Understanding the SWITCHING METHOD Settings
Setting the
VS-162V
unit as a Stand-Alone UNIT
1
•
NoVIS
- switching occurs immediately after completion of front
panel or dry-contact operation or immediately after receiving an
RS-232 or RS-485 command, or an IR command. The switching
is independent of the vertical reference
provides a choice of
three SWITCHING METHOD settings:
•
EXT
(external sync) - switching occurs during the vertical
interval of the video reference signal connected to the IN SYNC
2
1 Via the MACHINE ADDRESS setting (as section
11.4
describes)
2 Item 1 in
Figure 1
