Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
VS-211X
. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the
VS-211X
.
VS-211X
and
VS-411X
are identical
except for the number of inputs.
Setting the DIP-Switches
DIP-switches 1, 2 and 3 are set to ON (down) by default and DIP-switch 4 is always set to OFF (up).
DIP-switch changes take effect immediately.
#
Feature
Dip-Switch Settings
1
Switching Mode
OFF (up)
– Manual mode.
ON (down)
–Auto-switching mode.
2
Auto-switching Mode
OFF (up)
– Priority switching mode: the device
switches the source with the
highest priority to the output.
ON (down)
– Last connected switching mode: the last detected active source is
auto-switched to the output.
3
EDID lock
Off (up)
– EDID Locked.
On (down)
– EDID parameters are passed-through.
4
Reserved for Factory Use It is mandatory to keep set to OFF (up).
For optimum range and performance use the recommended Kramer cables available at
www.kramerav.com/product/VS-411X
Step 5: Connect the power
Connect the power cord to
VS-211X
/
VS-411X
and plug it into the mains electricity.
Safety Instructions (See
for updated safety information).
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the
terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
