Operating Your Video Matrix Switcher
17
17
22 23 24 25 26 27 28 29
00 00 00 00 00 00 00 00 In__ => Out 26
The left-hand side of the display shows a section of the output/input display,
automatically sliding the content to include output 26.
2. Using the numeric keypad, enter the required input (in this example, 14):
In the At Once mode, the switching takes place immediately and the
LCD display shows a segment of the input-output status that includes the
switched input and output (for example, 26-14)
In the Confirm mode, the LCD display shows the following:
In 14 => Out 26
Incomplete actions timeout after approximately 15 seconds.
In the Confirm mode, press the flashing TAKE button to switch the input
to the output
7.4.2 Switching Several Inputs to Several Outputs
If you want to switch several inputs to several outputs you must be in the Confirm
mode.
In the Confirm mode you can enter a batch of several actions and then confirm the
batch by pressing TAKE once (simultaneously switching several output-input
combinations).
To switch several inputs to several outputs in the Confirm mode:
1. Using the numeric keypad, enter an output-input combination.
The TAKE button flashes.
2. Enter additional output-input combinations.
The LCD display can show up to five keyed-in actions, as follows
1
09 => 06 05 => 07
:
3. After entering all output/input combinations, press the flashing TAKE button
to confirm the actions.
The inputs switch to the respective outputs as shown on the LCD display and
the TAKE LED lights solid.
7.4.3 Turning an Output Off
Turning an output off means that there is no input switched to this output.
To turn an output off:
1. Press MENU.
The Menu buttons light and are enabled.
2. Press OFF (3).
The following message is displayed:
out__ => OFF
1 In this example, input 9 is set to switch to output 6 and input 5 is set to switch to output 7
