KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your Video Matrix Switcher
18
3. Using the numeric keypad, enter the output to turn off.
The output is turned off.
To turn an output off in the Confirm mode, repeat the steps above and then press
the flashing TAKE button to confirm the action.
Alternatively, you can perform a switching operation (see
Section 7.4.1
7.4.4 Turning Off Several Outputs
) and set
the input to 00.
To turn off several outputs in the Confirm mode, repeat the switching actions
described in
Section 7.4.2
7.4.5 Recalling the Default Setup
but set the inputs to 00.
You can store a commonly used setup as the default setup (see
Section 8.2.6
Note:
This is not the setup that is loaded when the unit is turned on. When the unit
is turned on, the setup that was last used before the unit was turned off is loaded.
)
which can be recalled at any time.
To recall the default setup:
1. Press DEFAULT SETUP.
The DEFAULT SETUP button flashes and the following message is
displayed:
recall DEFAULT setup
press FLASHING button to confirm
2. Press DEFAULT SETUP.
The following message is displayed:
all Setups and Connections change
press TAKE to confirm
The TAKE button flashes.
3. Press TAKE.
The default setup is recalled and the display reverts to the output-input
display.
7.5 Locking the Front Panel Buttons
To prevent tampering with the unit or the settings from being changed accidentally
via the front panel buttons, you can lock
1
To lock the front panel buttons:
the
VS-3232DVI
.
•
Press and hold LOCK until the button lights.
To unlock the front panel buttons, press and hold LOCK until the button is no
longer lit.
1 You can still remotely operate via RS-232 or Ethernet even when the front panel is locked
