Using the Configuration Menus
25
25
The current status of the IR and Ethernet interfaces is displayed.
3. Press ENT to select the Interface Submenu.
4. Select 1 to modify the status of the IR interface or 2 to modify that status of
the Ethernet interface (in this example, 2).
The following is displayed:
Ethernet interface setup
1:make it ACTIVE
2:turn it OFF
5. Press 1 to activate the interface or 2 to deactivate it.
6. Press TAKE to confirm the action.
The interface status is changed. After a few seconds the next option on the
Config Menu is displayed.
8.2.4 Config Menu—Interface Reply Configuration
This option lets you switch the Reply configuration on or off. Setting Reply to on
causes all interfaces that are set to on to accept and execute commands, and also to
reply. Setting Reply to off causes all interfaces that are set to on to accept and
execute commands, but not to reply.
To switch the Reply configuration on or off:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
2. Press MENU until the following is displayed:
interface REPLY configuration
current interface REPLY -- ON
This indicates the current Reply configuration status.
3. Press ENT to enter the Reply Submenu.
The following is displayed:
interface REPLY configuration
1:turn REPLY ON
2:never REPLY
4. Press 1 to switch Reply on or 2 to switch it off.
5. Press TAKE to confirm the action.
A message is displayed indicating the new status of the Reply configuration.
After a few seconds the next option on the Config Menu is displayed.
8.2.5 Config Menu—Protocol Configuration
This option is for future use. At the time of printing the
VS-3232DVI
only
supports Kramer Protocol 2000.
8.2.6 Config Menu—Store Default Setup
This option lets you store the current setup as the default setup. The default setup
can be recalled at any time using the DEFAULT SETUP button (see
Section 7.4.5
).
