28
29
Putting into operation
Taking out of operation
1.
Switch off the high-pressure cleaner
2.
Cut off the water supply
3.
Open the safety trigger gun catch briefly until the pressure is released
4.
Apply safety catch on the trigger gun
5.
Remove Round Cleaner UFO and clean it with a damp cloth
6.
Check if the rotor is tangled with threads etc.
7.
Put the Round Cleaner UFO onto the floor in such a way that the splash
protection flaps can not be deformed due to rough ground.
8.
Remove high-pressure hose and safety trigger gun
9.
Emptying high-pressure pump: Hold high-pressure hose and switch
motor on until water jet stops escaping at the outlet.
10.
Pull the plug from the socket
11.
Clean high-pressure hose and wind up without loops
12.
Clean and wind up the power supply cable
13.
Clean the water inlet sieve
14.
Store high-pressure cleaner and Round Cleaner UFO
in frost-free rooms in winter
EN
Round Cleaner UFO short version
Especially for the cleaning of vertical
surfaces (Ord. no.: 41855)
Hold the Round Cleaner UFO firmly
by the handle and the safety trigger gun.
Wall cleaning with Round Cleaner UFO short version
The Round Cleaner UFO short version is equally effective when cleaning smooth,
vertical surfaces like facades, boat hulls etc.
Mount the Round Cleaner instead of the spray lance to the safety trigger gun
of your high-pressure cleaner.
Hold the Round Cleaner UFO firmly by the handle
and the safety trigger gun.
When cleaning sensitive surfaces try out the Round Cleaner on a barely visible
spot first and adjust the pressure so that the surface is not damaged.
Do not exceed max. pressure (see technical data).
No other persons or animals may be in the working area/near the
cleaning head.
Ensure a secure stand (danger of recoil) and hold the safety trigger gun
firmly with the extension tube or handle.
Always hold the Round Cleaner UFO briefly by the handle when cleaning
wall surfaces!
During operation the plug coupling must not be actuated/ touched!
High risk of injury!
The Kränzle Round Cleaner UFO can be operated with hot water of
max. 60 °C. Attention! Danger of scalding! Only touch metal parts
wearing gauntlets. Make sure to wear protective clothng!
