OM45T_
Rev N
Page 16
Figure 3-6: Optimum Polarization Settings
3.2 Removal of the Manual Actuator Assembly
After the satellite has been successfully acquired and all necessary adjustments are made, the manual actuator
should be removed. The following steps provide the procedure for properly removing the Manual Actuator
Assembly.
Step 1 of 3:
Remove the Manual Actuator Assembly by first removing the hardware that secures the actuator
to the base angle. Store the manual actuator assembly and corresponding hardware in a dry area for future
use.
NOTE:
The Adjustment Kit Assembly should be removed after the antenna has been adjusted.
Step 2 of 3:
Remove the remaining clamp segments, along with the corresponding hardware.
Step 3 of 3:
After the antenna is pointed at the satellite, tighten all Azimuth and Elevation setscrews to 35 foot
pounds.
