OM45T_Rev
N
Page 3
5.2.4 Prepping & Painting Galvanized Surfaces
25
5.2.5 Priming & Painting Cleaned Jack Surfaces
25
5.3 Removing Backlash via Jack Adjustment
25
5.4 Maintenance Kits
26
APPENDIX: Equipment Issues & Technical Support
27
List of Figures
Figure 1-1a: Bolts Shorter than 4 Diameters
9
Figure 1-1b: Bolts Longer than 4 Diameters
9
Figure 1-2: Scraping Foundation Pads
10
Figure 3-1: Pure Noise Signal on Spectrum Analyzer
13
Figure 3-2: Minimum Transponder Signal on Spectrum Analyzer
13
Figure 3-3: Antenna Radiation Pattern Topographical Diagram w/ Plan View
14
Figure 3-4: Polarization at 45 Degrees from Optimum Setting
15
Figure 3-5: Maximizing Odd Transponders
15
Figure 3-6: Optimum Polarization Settings
16
Figure 5-1: Jac/Jack Anti-Backlash Procedure
26
List of Tables
Table 1.1: Recommended Tools
8
Table 1.2: 7.6m Assembly & Installation Drawings
10
Table 4.1: Lubrication Chart
23
Table 5.1: Cure Times
25
Table 5.2: Maintenance Kits
26
