6
Manual
www.kraun.it
2. SAFety inStRUctiOn
This chapter mainly introduce the safety marks and notes of 1kVa-3kVa series on-line UPS. Read this chapter
carefully before operating on the equipment.
2.1. SAFety inStRUctiOn
There is dangerous voltage and high temperature inside the UPS. During the installation, operation and main-
tenance, please abide the local safety instructions and relative laws, otherwise, it will result in personal injury
or equipment damage. Safety instructions in this manual act as a supplementary for the local safety instruc-
tions.
our company will not assume the liability that caused by disobey of safety instructions. Please note the fol-
lowing:
1.
Don’t use the UPS when the actual load exceeds the rated load.
2. There are high-capacity batteries in the standard type UPS. You mustn’t open the enclo-
sure or it will lead to electric shock. If it needs internal maintenance or battery replace-
ment, please send it to the designated site.
3. Internal short-circuit of the UPS will cause electric shock or fire. So don’t place the contain-
ers equipped with liquid on the top of the UPS so as not to cause danger of electric shock
and so on.
4. Don’t put the UPS in a place with high temperature or humidity as well as the corrosive
gas, much dust.
5. keep good air circulation between in-vent on front panel and out-vent on back panel.
6. avoid direct sunlight or near heat-dispensed objects.
7. In case that the smoke appears on the UPS, please cut off the power as soon as possible
and contact the dealer service site.
2.2. SyMbOLS indicAtiOn
The safety symbols cited in this manual are shown in table 1-1, which are used to inform read-
ers of safety issues that should be obeyed when installation, operation and maintenance.
Safety Symbol
Indication
attention
Static discharge sensitive
electric shock
