KRAUSMANN 8506, Operation Manual

13

KRAUSMANN  POWER TOOLS

8506

4

Fixing

screw

English | 

EN

Installing and removing the guard 

       WARNING:

B

efore plugging in the tool, always check to see that the 

switch trigger actuates properly and returns to the OFF 

position.

The operation guard 

4

 is held in place by a clamp 

ring secured to the grinder head by a screw (fig 

1). Loosen the fixing screw and rotate the guard 

to the desired position, where it will deflect hot 

sparks away from the operator. Then tighten the 

fixing screw. To remove, follow the procedure in 

reversed order.

fig 1

Attaching the auxiliary handle

Ensure the tool is switched off and unplugged

at the mains. Identify the three threaded holes on 

each side of the grinder head. Screw the auxiliary 

handle 

5 

firmly into one of them (fig 2).

SAVE THESE INSTRUCTIONS

4. Functional description  

    and specifications

       WARNING:

M

isuse or failure to follow the safety rules stated in this 

instruction manual may cause serious personal injury.

       WARNING:

I

f the replacement of the supply cord is necessary, it has 

to be done by a professional to avoid a safety hazard.

Intended use

The angle grinder is intended for grinding and 

cutting masonry and metal.

Do not use adjusters or other aids to fit discs 

with a different axle diameter.

M

ake sure the piece is properly supported or 

tightened.
Never use cutting discs for edging or grinding.

M

ake sure the sparks do not get in contact 

with an individual or flammable materials.
Always wear safety goggles, earplugs and 

other protection gear, like working gloves, 

protective clothing, hard hat etc.

I

f the guard has not been installed, do not 

operate the tool under any circumstances.

M

ake sure the ventilation openings are kept 

clean. Especially when working in environ-

ments rich in dust.
Always remove the tool from the plug before 

removing dust.

I

n order to prevent damage to the tool’s 

internal parts, do not use cleaning brushes, 

metallic or similar objects to remove dust.
Bear in mind that after you turn off the 

machine, the axle or disc keeps rotating for a 

short period of time.

Power supply
Power input
No load speed

230V~50Hz

900W

12000/min-1

Tool

8506

Disc diameter
Axle threading
Weight

Ø125mm

Μ14

1,76kg

      NOTE:

M

ake sure that the screw and nut are tight enough so that 

the disc guard cannot be moved. Τhe operation guard 

must be fitted to the angle grinder at all times during use.

i