16
9851
KRAUSMANN POWER TOOLS
English |
EN
9
6
Tighten
Loosen
Auxiliary handle
The auxiliary handle swings around to either
side, allowing easy handling of the tool in any
position. Loosen the auxiliary handle
6
by turning
it counterclockwise, swing it to the desired position
and then tighten it by turning clockwise (fig 6).
WARNING:
A
lways be sure that the tool is switched off and unplugged
before carrying out any work on the tool.
WARNING:
A
lways use the auxiliary handle to ensure operating safety
when drilling in concrete, masonry etc.
Όhen the bit begins to break through concrete or if the
bit strikes reinforcing rods embedded in concrete, the tool
may react dangerously. Maintain good balance and safe
footing while holding the tool firmly with both hands to
prevent dangerous reaction.
For drilling in wood, metal or plastic materials,
rotate the mode selector switch
3
so that the
pointer points to the symbol . Rotate the mode
selector switch
2
so that it points to the symbol
(fig 4). Use a twist drill bit or wood bit.
Drilling
3
2
fig 3
3
2
fig 4
WARNING:
T
he following combination can not output any
function (fig 5).
3
2
fig 5
fig 6
5. Assembly
The depth gauge
9
is convenient for drilling holes
of uniform depth (fig 6).
Depth gauge
NOTE:
The depth gauge cannot be used at the position where the
depth gauge strikes against the tool body.
i
Coat the bit shank head beforehand with a small
amount of bit grease (about 0.5 - 1 g / 0.02 - 0.04
oz). This chuck lubrication assures smooth action
and longer service life.
Lubrication
