KRAUSMANN U87020-00B, Operation Manual

9

KRAUSMANN  POWER TOOLS

U87020-00B

5. Maintenance

Correct and regular cleaning will improve the safe-

ty and extend the lifespan of the device.

For safe and proper working, always keep the 

tool and ventilation slots clean.

Τhe tool may be cleaned most effectively with 

compressed dry air or with a soft cloth moistened 

with soapy water. 

Always wear safety goggles 

when cleaning tools with compressed air.
Certain cleaning agents and solvents damage 

plastic parts.

 Some of these are: gasoline, carbon 

tetrachloride, chlorinated cleaning solvents, 

ammonia and household detergents that contain 

ammonia.
Store the tool, operating instructions and where 

necessary the accessories in the original packag-

ing. In this way you will always have all the informa-

tion and parts ready to hand.

       WARNING:

T

urn the device off, disconnect it from the mains and wait 

until it cools down before cleaning or maintenance to 

avoid electric shock or burn.

Wear ear defenders

Wear safety goggles

Wear a dust mask

This tool has been checked by the manufacturer. 

From the date of purchase by the final consumer, 

a two year warranty for 

amateur use

covers any 

faulty material and manufacturing. The receipt or 

invoice of purchase needs to be displayed in case 

of a repair that is covered by the warranty. For 

possible faults during the warranty period, you 

should address your issue to the retail shop from 

which the purchase was made.

6. Warranty

The tool has been used properly and for the 

purpose for which it was purchased.
The tool presents a problem that is due to 

faulty material and manufacturing.
Incapability of the tool to perform according 

to the technical specs provided.

Damages are not covered by the warranty that are 

due to causes such as:

Wear due to improper use.

Partial or total disassembly.The tool’s shell 

must be disassembled only by personnel 

authorised by the official distributor.

Damage due to overloading.

U

sage of incorrect or incompatible accessory.

Bad maintenance from the operator or any 

other third party.
Wear that was induced by external factors or 

rogue particles (dust, debris etc.)

Wear due to non compliance with the instruc-

tions in this manual.

If, during the warranty period, there is a fault that 

can not be repaired from the authorised service 

department, the tool will be replaced without any 

extra cost.

Terms of warranty

The warranty is valid only when:

In case there is a need for a repair after the war-

ranty period has expired, we will provide the best 

possible attention to repair the tool successfully.

7. Repair / Servicing

collection systems for information regarding the 

collection systems available.
I

f electrical machines are disposed of in landfills 

or dumps, hazardous substances can leak into 

the groundwater and get into the food chain, 

damaging your health and well-being. When 

Do not dispose of electrical 

machines as unsorted municipal 

waste, use separate collection 

facilities.
Contact your local government 

8. Disposal

English | 

EN