Removing the control valve
Fig. 13: Control valve
8.
Unscrew the screws ( Fig. 13/4).
9.
Remove the control valve ( Fig. 13/3), throttle ( Fig. 13/2) and seal ( Fig. 13/1).
10.
Check the throttle ( Fig. 13/2) and seal ( Fig. 13/1) for damage and replace it as necessary.
Installing the control valve
11.
Insert the seal ( Fig. 13/1) and throttle ( Fig. 13/2) in the order shown.
12.
Put on the control valve ( Fig. 13/3) and fasten it in place with the screws ( Fig. 13/4).
Operating instructions
T-Dok-300-GB-Rev.1
mail@krautzberger.com, www.krautzberger.com
GB–38
