K-300i Owner’s Reference
© 2018 by Krell Industries LLC. All rights reserved.
Page 4 of 18
Unpacking / Placement / AC Power Guidelines
Open the shipping box and remove the top layer of foam. You will see these items:
K-300i unit and Accessories - Included
1 - AC power cord
1 - Handheld remote control
2 - AAA batteries
1 - Owner’s reference
1 - Warranty Registration card
1 - Trigger cable
1 - T-10 Torx Screwdriver
Place the K-300i on a firm, level surface, away from excessive heat, humidity, or moisture. The K-
300i is a precision instrument and should be handled with the utmost care. Make sure the
installation location is dry and level, and able to provide adequate ventilation. The K-300i runs warm
to the touch and requires the bottom and top of the unit be free from obstruction with good
circulation of air. The bottom of the K-300i must be unobstructed to the height of the feet to ensure
proper ventilation. Do not place the K-300i on a carpeted floor. Allow a minimum of 2 inches (5cm)
above the unit for proper ventilation, and at least one inch (2.54 cm) on each side. Additional
ventilation may be required when the unit occupies the same space with other electronics that
generate heat, like power amplifiers. Please consult an authorized KRELL dealer or KRELL
Industries to ensure proper installation.
The K-300i is designed to work all over the world. The operating voltage is determined at the factory
and is specifically set to operate in the country of final destination. The K-300i requires good clean
power and doesn’t require additional filtration. A 15 amp circuit is recommended for the K-300i.
Note:
The K-300i may not operate correctly when AC regeneration or voltage conversion devices are
utilized. If you choose to use such a device, at a minimum they must be rated for the maximum
power consumption of the K-300i(900 Watts).
Note:
Save all packing materials; if you need to ship the K-300i in the future, repack the unit in its
original packaging to prevent shipping damage.
Recommended Cleaning Instructions for Krell Products
Clean your Krell product gently, using a high quality lint-free cloth that has not been treated with
chemicals of any kind. Please note the following: Do not use cleaning agents of any kind, such as
alcohol, Windex, or other common cleaning products. Water may be used but do not spray directly
onto the unit, instead a small amount may be used on a lint-free cloth to lightly rub the exterior of the
unit.
Thank you.
