KREMLIN REXSON
N° : 578.001.120-UK-0910
3. M 22 HTI – HPA (G)
3.1. Description
Guns recommended to spray varnishes, lacquers, shades, polyurethanes, two components...
The HTI guns are pneumatic guns with a high transfer efficiency. Two projectors, models EP 5 and
E 5 K HVLP can be fitted on the same gun.
The guns, model HPA, with high spraying quality, enable to spray any kind of materials (low or high
viscosity).
3.2. Technical features
FEATURES
HTi
(E 5 K HVLP aircap)
HTi
(EP 5 aircap)
HPA
(EN 5 aircap)
Maximum air supply pressure (network)
6 bar / 87 psi
Air pressure at the gun handle
From 1,5 to 2,5 bar /
from 22 to 36 psi
From 2 to 3 bar /
from 29 to 44 psi
From 2 to 4 bar /
from 29 to 58 psi
Air flow
27,2 m3/h to 2 bar /
16 CFM to 29 psi
20,2 m3/h to 2,5 bar /
11.9 CFM to 36 psi
26,5 m3/h to 2,5 bar /
15.6 CFM to 36 psi
Fluid supply
Gravity cup (0,6 liter)
Weight (gun without cup)
530 g / 1.17 lb
Weight (gun with cup)
690 g / 1.52 lb
Shades and hydro or solvent based
varnishes
-
low
viscosity
* * * *
* * *
* * *
- middle viscosity
* * * *
* * * *
* * * *
- high viscosity
* *
* * *
* * * *
Minimum transfer rate
(EN 13966-1 standard)
76 % ± 2 %
74 % ± 2 %
-
Maximum fluid temperature
50° C / 120° F
Nozzle, needle, fluid passage
Stainless steel / Stainless steel / anodized aluminium
White cup (acetale resin)
For hydro and solvent based paints
Grey cup (PEHD)
For PU and pre catalysed materials
Note : For HVLP compliance, the maximum inlet air pressure at the gun handle must not exceed 29 psi
(2 bar) to maintain 10 psi (0,68 bar) or less at the air cap. Testing for HVLP compliance was performed
using the specified HVLP test air cap, the fan control fully open and a pressure gauge on the air inlet
fitting at the gun handle. It may also be a requirement of some regulatory agencies that users have the
appropriate test air cap available on site to verify that the gun is being operated within the regulatory
limitations.