16
EN
your MissionNANO™.
3) Lift the rear of MissionNANO™ to access the underside.
4) Open the protective rubber cover under MissionNANO™ to access the USB port.
5) Insert the USB drive (flash drive) in the port. (See Fig. K)
6) Place MissionNANO™ on the ground again.
7) Turn the main switch to the “I” position to turn on
MissionNANO™.
8) The battery indication light will start to pulse. When
the error indication light flashes blue, the file has been
copied.
9) Without lifting MissionNANO™, remove the USB drive
(flash drive).
10)The update will begin automatically and may take
several minutes. The final alert sequence will include a
beep, and both the battery indication light and error indication light will flash. When the error indication light
turns off and only the green battery indication light remains lit, the update is complete.
NOTE:
If MissionNANO™ is not inside the boundary wire, the error indication light will flash RED after the
update. Please refer to the manual for more information.
(11)Be sure to tightly and completely close the rubber protective USB port cover.
Method 2:
Update via your smartphone.
If your MissionNANO™ is connected to your smartphone via the MissionNANO™ App, you can check the
software version. The App will also notify you when new software version is available.
The manual included with your MissionNANO™ is based on the default software at the time of production.
Some new features/functions in the new version may not exist in the manual. If you found some settings not in
the manual, please visit www.kress-robotik.com to download the latest manual.
9. Maintenance
Your MissionNANO™ works hard and needs to be cleaned and checked from time to time. Some parts will
require replacement as they become worn. Never use your MissionNANO™ with defective main switch.
Switch off the machine before carrying out any service or maintenance.
Here's how to take care of your MissionNANO™.
9.1 Keep it Sharp
WARNING:
Before cleaning, adjusting, or
replacing the blades, turn your MissionNANO™
OFF and put on protective gloves.
WARNING: When fitting new blades, make sure
you replace ALL the blades. Always use new
screws when fitting blades. This is important to
ensure blade retention and balance the blade turning
disc. Failure to use new screws could cause serious
injury.
MissionNANO™ does not cut grass like other mowers.
Its cutting blades are razor sharp on 2 edges and rotate in both directions for maximum cutting capacity (See
Fig. L). Each blade of your MissionNANO™ has 2 cutting edges. The blade turning disc will make forward
and reverse rotation at random to use both cutting edges and minimize the frequency of replacing the blades.
Each cutting blade will last up to 2 months when it is programmed to mow everyday. Always check to see if
the blades are chipped or damaged and replace them if they are. When the cutting blades are dull and worn
out, they should be replaced with the spare blades provided with your MissionNANO™. Spare blades are also
available at your nearest Kress retailer.
A. Replace the Blades
After some time, usually every season, your MissionNANO™’s Blades will need to be replaced. When
1
2
