22
EN
MissionNANO
TM
turns on, but
the blade disc does not move.
MissionNANO
TM
is searching for
the charging base (unless you
press the HOME button to make
it go to the charging base, or the
“Enable boundary cut” function
is operating).
This is normal. MissionNANO
TM
needs to
recharge, the blade disc does not rotate
while it is searching for the charging
base
automatically.
MissionNANO
TM
vibrates.
Blades may be damaged.
Check condition of the Blade
Disc.
Check the blades, and replace them if
damaged.
Remove debris and foreign objects from
the blades and blade disc.
Grass is being cut unevenly.
MissionNANO™ does not work
enough hours per day.
Add more hours to the scheduled
mowing time.
Mowing area is too big.
Try decreasing the size of the mowing
area or adding more hours to the
mowing time.
Blades are dull.
Change all the blades and screws in
order to balance the blade disc.
The cutting height is too low for
the length of the grass.
Raise the cutting height and then
gradually lower.
Grass or other object has
wrapped around the blade disc.
Check the blade disc and remove the
grass or other object.
There is a build-up of grass in
the blade disc or motor frame
box.
Make sure the blade disc rotates easily.
If need be, you may take off the blade
disc and remove the debris.
Your MissionNANO
TM
is inside
its territory and the boundary
wire is connected. The error
indication light flashes red.
The boundary wire ends are
clamped incorrectly.
Reverse the boundary wire ends.
The charging time is far more
than 2h.
Poor connection caused by
debris on the charging strip.
Clean the contact pins located on the
charging base and the charging strip on
MissionNANO
TM
using a cloth.
The charging protection
program has activated due to
high temperature.
Place the charging base in a shady area
or wait until the temperature has cooled
down.
The mower does not charge.
There is no power.
Check the power cord is connected
properly to the charger and the charger
is connected to a suitable power
supply.
Does not operate correctly
while manually charging.
Refer to manual charging.
MissionNANO
TM
is starting
to have shorter run-times
between charges.
Something is clogging in the
blade disc.
Take off the blade disc and clean it
The grass is too high and too thick.
MissionNANO
TM
is shaking
heavily.
Check the blade disc and blades,
remove debris and foreign objects from
the blades and blade disc.
The battery may be exhausted
or old.
Replace battery.
