23
EN
MissionNANO
TM
is not
operating at the correct time.
The clock is not set to the
correct time.
Set the clock to the correct time by
using App.
Programmed cutting times for
MissionNANO
TM
are not correct.
Change the time settings for the mower
to start and stop.
MissionNANO
TM
is manually
docked in the charging base.
Press START and then OK.
MissionNANO
TM
cannot
correctly dock with the
charging base.
Environmental influences.
Restart MissionNANO
TM
.
Poor connection caused by
debris on the charging strip.
Clean the contact pins located on the
charging base and the charging strip on
MissionNANO
TM
using a cloth.
The green light on the
charging base turns on before
charging is complete.
The charging base is overheating,
the battery indication light flashes
red.
Place the charging base in a shady area or
wait until the temperature has cooled down.
MissionNANO
TM
runs
outside the boundary wire.
MissionNANO™ does not
mow an area within a boundary
wire zone. MissionNANO™
reverses or rotates erratically
near the boundary wire.
The boundary wire of another
MissionNANO
TM
or another
robotic mower is positioned too
closely.
Ensure your MissionNANO
TM
boundary
wire has at least 1m of space between
the neighboring boundary wire.
The boundary wire has been
installed with tight corners.
Check the boundary wire to ensure the
corners are smooth.
In wet conditions, the boundary
wire electric signal may leak
were wire has been joined or
repaired.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
There is boundary wire electric
signal leakage due to broken
insulation.
Repair damaged boundary wire
insulation with connectors.
The cutting area is larger than
the allowable cutting area for
MissionNANO
TM
.
Contact service agent.
MissionNANO
TM
wheels skid or
damage lawn.
Foreign obstacles, such as
twigs and branches may be
lodged under MissionNANO
TM
.
Remove foreign objects from underside
of MissionNANO
TM
.
The lawn is too wet.
Wait until lawn has dried.
MissionNANO
TM
exits the
boundary wire due to high
speed when going down a hill.
The boundary wire is placed on
a slope steeper than 17% (10°).
Reposition the boundary wire away from
slopes that are steeper than 17% (10°).
Please refer Installation Guide for details.
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
