6
Hand drill
KU120
1. KEY CHUCK
2. FORWARD AND REVERSE ROTATION CONTROL
3. LOCK ON BUTTON
4. ON/OFF SWITCH
Not all the accessories illustrated or described are
included in standard delivery.
TECHNICAL DATA
Voltage
220-230V~50Hz
Power input
650W
No load speed
0~3000r/min
Chuck capacity
13mm
Drilling capacity
Steel
13mm
Aluminum
13mm
Wood
25mm
Machine Weight
1.7kg
Protection class
/ll
ACCESSORIES
Chuck key
1
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
ASSEMBLY AND OPERATION
ACTION
FIGURE
Inserting bits into chuck
See Fig. A1, A2
Plugging in the power
See Fig. B
On/off switch and lock-on button
See Fig. C
Forward and reverse rotation
control
NOTE: Never move the
forward/reverse switch whilst
the drill in operation or the
on/off switch is locked as this
will damage the drill.
See Fig. D
WORKING HINTS FOR
YOUR DRILL
If your power tool becomes over heated, set the speed
to maximum and run no load for 2-3 minutes to cool the
motor. When drilling in metal, only use HSS drill bits in
good condition. Always use a magnetic bit holder when
using short screwdriver bits. Where possible use a pilot
hole before drilling a large diameter hole.
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust. Occasionally
you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your power tool does not start, check the plug on the
power supply first.
2. If the drill doesn’t work properly, check the drill bit for
COMPONENT LIST
