8
Lithium-Ion Brushless Impact Wrench
KUB30 KUB30.2 KUB30.9
Lithium-Ion Brushless Rotary Hammer
KUC61 KUC61.2 KUC61.9
COMPONENT LIST
1.
DEPTH GAUGE
2.
DUST PROTECTION CAP
3.
TOOL HOLDER LOCKING SLEEVE
4.
FUNCTION MODE SELECTION SWITCH
5.
ON/OFF SWITCH
6.
FORWARD AND REVERSE ROTATION
CONTROL
7.
BATTERY PACK*
8.
AUXILIARY HANDLE
9.
BATTERY PACK RELEASE BUTTON
10. AUXILIARY FUNCTION BUTTON ON TILE
* Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type Designation: KUC61 KUC61.2 KUC61.9
(C61 designation of machinery, representative
of hammer)
KUC61
KUC61.2
KUC61.9
Voltage
20V Max**
No load speed
0-1210 rpm
Impact rate
0-5400 bpm
impact energy
2.2 J
Battery model
Li-ion
(KAB21)
/
Battery capacity
4.0 Ah
/
Max. drilling
capacity
Steel
13 mm
Wood
27 mm
Masonry
24 mm
Machine weight
3.2 kg
2.6kg
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
ACCESSORIES
KUC61 KUC61.2 KUC61.9
4.0Ah battery
pack(KAB21)
2
2
/
6A charger(KAC21)
1
1
/
Auxiliary handle
1
1
1
Depth gauge
1
1
1
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and offer
advice.
OPERATING
INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for drilling
without impact in wood, metal, ceramic and plastic.
Before Putting Into Operation
A) Charging The Battery Pack
The battery pack charger supplied is matched to the Li-
ion battery installed in the machine. Do not use another
battery charger.
The Li-ion battery pack is protected against deep
discharging. When the battery pack is empty, the
machine is switched off by means of a protective circuit:
The chuck no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow time
for the battery pack to cool down before recharging.
When the battery pack is charged for the first time and
after prolonged storage. The battery pack will accept a
100% charge after several charge and discharge cycles.
B) To Remove Or Install Battery Pack (See Fig.
A)
Depress the battery pack release button to release and slide the
battery pack out from your tool. After recharge, slide it
back into your tool. A simple push and slight pressure
will be sufficient.
OPERATION
1. INSERTING AND REM CAP OVING DRILL BIT IN SDS
Take care that the dust protection (2) is not damaged
when changing tools.
Summary of Contents for KUC61
