14
EN
Troubleshooting
If your Mission
TM
does not work correctly, follow the trouble shooting guide below. If the fault persists, contact
your dealer.
Symptom
Cause
Solution
The LED light on the
charging station does
not turn on.
There is no power.
Check the charging station is connected
properly to the charger and the charger is
connected to a suitable power supply.
Red light turns on the
charging station.
The boundary wire isn’t connected.
Check that the boundary wire has been
connected correctly to the charging station.
Check there are no breaks in the boundary
wire, especially in the wire ends.
Your Mission
TM
is
inside its working
area but the display
says “outside
working area” and
the LED is green.
The boundary wire ends are
clamped incorrectly.
Reverse the boundary wire ends.
Mission
TM
cannot
correctly dock with
the Charging station.
Environmental influences.
Restart Mission
TM
.
Poor connection caused by debris
on the charging strip.
Clean the contact pins located on the
charging station and the charging strip on
Mission
TM
using a cloth.
Mission
TM
runs
outside the boundary
wire. Mission
TM
does
not mow an area
within a boundary
wire zone. Mission
TM
reverses or rotates
erratically near the
boundary wire.
The boundary wire of another
Mission
TM
or another branded robotic
mower is positioned too closely.
Ensure your Mission
TM
boundary wire has at
least 1m of spacing between the neighboring
boundary wire.
The boundary wire has been
installed with acute angles.
Check the boundary wire to ensure the
angles are smooth.
In wet conditions, the boundary wire
electric signal may leak where wire
has been joined or repaired.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
There is boundary wire electric signal
leakage due to broken insulation.
Repair damaged boundary wire insulation
with insulation tape.
The cutting area is larger than the
allowable cutting area for Mission
TM
.
Decrease the cutting area.
Mission
TM
exits the
boundary wire due
to high speed when
going down a hill.
The boundary wire is placed on a
slope steeper than 17% (10°).
Reposition the boundary wire away from
slopes that are steeper than 17% (10°).
The position of
Mission
TM
cannot
be shown precisely
on the App, or its
position cannot be
detected.
The GPS signal is affected by the
weather or some interference.
1.Check and make sure: Mission
TM
is not
upside down or on its side; Mission
TM
is not
covered by some metal objects.
2. Take Mission
TM
to an open area where it
can obtain a mobile signal.
You are not using the latest version
of the Mission
TM
App.
Please update the Mission
TM
App to the
latest version.
Summary of Contents for MISSION KR133E
