For initial set up, we strongly recommend that you also refer to the relevant manual!
System Configuration
Diameter range and rail versions
100…240 VAC (Vnom), 50...60 Hz
12 VDC, 2.33 A, Pmax 28 W
A - B
1 2
Sensor cable connections
3
I/O connections
Small
Medium
4
Mains supply connection
Medium
Large
12/2021 - 4009151901 - OPTISONIC 6300 P R01 en
1
2
before every use
DN200…2000 / 8…80"
DN50…250 / 2…10"
DN200...4000 / 8...160"
DN15…50 / 0.5…2"
W-mode
V-mode
Z-mode
V-mode
1 rail
2 rails
Channel (A-B) 1 / 2 path measurement
General
Ta = -10…+45°C / +14…+113°F
Maximum ambient and process temperatures
are depending on version (e.g liner material,
size), temperature and protection class
and maximum surface temperature of sensor.
Check the device nameplate to ensure that the device is
delivered according to your order.
The responsibility as to the suitability, intended use and corrosion resistance of the used materials against the
measured fluid of this device rests solely with the operator.
1 Electrical connection
This device cannot be used in Hazardous Locations or Explosive Gas Atmospheres!
All work on the electrical connections may only be carried out with the power disconnected. Take note of
the voltage data on the nameplate! Observe the national regulations for electrical installations!
Observe without fail the local occupational health and safety regulations. Any work done on the electrical
components of the measuring device may only be carried out by properly trained specialists.
Charge the battery of the signal converter completely before using.
Check for damage
Quick Start
Quick Start
OPTISONIC 6300 P
General
Device nameplate
Portable ultrasonic clamp-on flowmeter for liquids
Installation, assembly, start-up and maintenance may only be performed by appropriately trained personnel.
Check the nameplate for correct operating conditions.
This instrument complies with requirements of Low Voltage Directive. Instruments must not be connected to
power supply before reading instructions described in the manual.
Tp = -40...+120°C / -40...+248°F
12V DC Power adaptor (charger), mains
supply data:
Electrical connections signal converter
