UFM
3030
13
5.2
Menu structure and function of operating keys
The menu structure consists of user accessible blocks.
•
Function block 0 Error/Totalizer reset can be accessed from the measuring mode and provides
detailed information on errors occurred during operation. It allows for fast and easy resetting of
the errors and Totalizers.
•
Function block 1 Operation contains a subset of options from function block 3, Installation. The
options in function block 1 are selected so that the most commonly used functions can be
selected quickly from this menu. In most cases only function block 1 needs to be accessed in
order to perform the required setting or programming task.
•
Function block 2 Test contains all available test functions. This block can be accessed to check
proper functioning off all converter hard- and software.
•
Function block 3 Installation contains all other set-up parameters for the converter. In general
the converter is factory-preset. See Service Handbook for modification instructions.
•
Function block 4 Parameter Error becomes active automatically when non-plausible values have
been programmed, e.g. a too high a flow rate in too small a diameter. If this is the case menu 4
will indicate that either FULL SCALE or METER SIZE needs to be changed.
The figure below shows the main operation structure of the converter. The cursor or flashing part of
the display is shown as underlined text. For a complete overview of the menu see the Service
Handbook.
