KRONAsteel BELLA, Application Sheet

4

EN  Application sheet

KITCHEN HOODS

kitchen, smells, char and soot pas through reus-

able aluminum grease trap filters and are removed 

outside the premises. With this working mode, it is 

not necessary to install charcoal acrylic scent-trap 

filters. Extraction mode is the most efficient as the 

kitchen hood removes all the evaporations from 

the kitchen to the air shaft.

In the recirculation mode (see Fig. 5), the kitchen 

hood is not connected to the air shaft, and thus the 

air is just passed through the kitchen hood inside 

the kitchen.

In this mode, charcoal acrylic disposable scent-

trap filters should be installed on the kitchen hood. 

These filters are not included in the set and are 

bought separately. The use of the kitchen hood in 

the recirculation mode reduces its productivity.
We recommend using the kitchen hood in the 

mode of air extraction to the air shaft.

MAINTENANCE AND SERVICE  

OF THE KITCHEN HOOD

Disconnect the power supply before you 

start any operation related to cleaning or re-

pair of the kitchen hood.

Use the cloth damped in warm water with a neutral 

detergent for external cleaning of painted kitchen 

hoods. Use special detergents and follow the rele-

vant instructions for external cleaning of steel, cop-

per and brass surfaces. Never use the detergents 

that contain acids or chloride, abrasive products or 

sponges that may scratch the surface.

The aluminum grease trap filter becomes polluted 

as it traps the particles of fat coming through it. It 

should be cleaned with products that do not con-

tain acids or washed after preliminary soaking in 

hot water using an efficient detergent or, if possible, 

in the dish-washer (at a temperature of 65°C). Ex-

tremely polluted grease trap filters should not be 

washed in the dish-washer along with kitchenware. 

Aluminum filters should be cleaned once in 1.5-2 

months, which will be reminded by a relevant signal 

on the display of the kitchen hood remote control 

(see the remote control description in the para-

graph “Kitchen hood control”).

Simultaneously with cleaning of the grease trap fil-

ter, clean all the accessible elements of the kitchen 

hood case from grease deposits.

To disconnect the aluminum filter (Fig. 6), press the 

spring lock on the filter and pull it and then press 

down to remove. When you remove the filter, do not 

apply the effort to the aluminum surface of the filter 

as it may lead to dents on its surface, affecting the 

external appearance of the filter.

Do not install the filter in the kitchen hood until it 

is completely dry. 

The filter is installed in the reverse order. Press the 

spring lock on the filter and put it in place, after 

which release the lock.

Installation of carbon filters

Coal filters, if they are installed and the hood 

works in recirculation mode, should be changed 

every 5 months. For your hood, two coal filters 

are installed. They are mounted on the protective 

grilles of the motor duct by lightly pressing and 

turning them clockwise. To remove the carbon 

filter, it should be slightly squeezed and turned 

counter-clockwise (Fig. 7).

Replacing the backlight

To replace the backlight, it is necessary (see Fig. 

8) to:

–  disconnect the hood from the power supply and 

find the burned out lamp wire;

–  disconnect the power cable in the connector 

by pressing the two lobes of the hood plafond, 

removing the burned out lamp 

–  insert a new one into the place of the burned out 

backlight;

–  connect the lamp power lead in the connector;

–  connect the hood to the mains and check the 

operation of the backlight.

Replacement of bulbs and filters is not included 

in the warranty service.