12
EN Application sheet
KITCHEN HOODS
and lighting turn off, but the hinged panel remains
opened.
This function is very useful for eliminating the
odours remaining in the kitchen after the cooking
is finished.
GREASE FILTERS SATURATION
INDICATOR
Sometimes you will see the icon
. lighting up
on the display (3) (see Pic. 4). This icon lighting up
means that it is time to clean the aluminium grease
filter. This manipulation is very important for cor-
rect and safe operation of the cooker hood. After
the filter is cleaned, the icon should be turned
off. To do so, touch and hold the
icon for not
less than 5 sec. This will make the
icon blink
several times and disappear until the next time of
grease filter cleaning.
REMOTE CONTROL FUNCTIONS
(see Pic. 4a
There is another way of regulating the operation of
the cooker hood apart from the control panel – the
remote control. The remote control has even more
functions that the sensor touch control panel. Cer-
tain manipulations can only be done with the use
of the remote control.
IMPORTANT! The remote control is provided
with the pre-installed battery. To prevent the
battery from discharging before the cooker
hood is turned on for the first time, the remote
control has a protective film pre-installed. Re-
move this film before the first use of the cooker
hood. The pre-installed battery is only used for
demonstration purposes, and its replacement
is beyond the warranty service maintenance.
The out-of-order battery should be replaced
with the battery of the same characteristics.
Touching the
icon on the remote control turns
the cooker hood on and opens the hinged panel in
the same way as it happens when the same icon
on the sensor touch panel is activated. Unlike the
sensor touch control panel, pressing the
but-
ton again turns the cooker hood off and closes the
hinged panel, after which the cooker hood goes to
standby mode.
Press
button (see Pic. 4a, 5) to go to timer
setting mode. This can only be done if the motor is
activated. Repeated pressing this button increas-
es the timer interval by 15 min, to the maximum
value of 60 min. To increase the value by 1 min,
press the
button; press the
– button to
reduce the interval by 1 minute. To exit the setting
mode press the
button or wait for around 10
sec.
If you press the
button (see Pic. 4a, 3)) when
the motor is off, the cooker hood will go to time
setting mode. By pressing
or
buttons set
up the necessary hours value, and then press
,
again to proceed to the minutes value (control the
value by the
or
buttons). To exit the setting
mode press the
button or wait for around 10
sec.
The
button switches between the fan speeds.
Press the
button on the remote control to
open the hinged panel. This will lead to the
, icon appearing on the display, which means the
cooker hood is in the service maintenance mode.
The motor and lamps of the cooker hood will be
turned off. This function is specially designed for
providing safe conditions for maintenance and
cleaning of the cooker hood. To exit the mainte-
nance mode press the
button again.
