KRONAsteel JESSICA, Application Sheet

10

EN  Application sheet

KITCHEN HOODS

Replacement of coal filters

Coal filters, if they are installed and the hood works 

in recirculation mode, should be changed once ev-

ery 5 months. For your hood,  two coal filters are 

installed. They are installed on aluminum grease fil-

ters. To remove the coal filter, it should be carefully 

removed from the pressure plates mounted on the 

aluminum grease filter.

Replacing the backlight lamps

To replace the backlight lamp (Fig.12), it is neces-

sary to:

-   disconnect the steam sip-off machine from the 

power supply and find the wire of the burnt 

lamp;

-   disconnect the power cord in the connector by 

pressing two petals of the steam sip-off machine 

cover, remove the burned lamp;

-   insert a new lamp in place of the burned-out 

backlight lamp;

-   connect the lamp power wire in the connector;

-   connect the steam sip-off machine to the power 

supply and check the operation of the lamps.

The removal and replacement of the lamps and 

filters is not included in the warranty service.

KITCHEN HOOD INSTALLATION  

INSTRUCTION

These are only trained professionals who are 

permitted to install and connect kitchen hoods. 

It is prohibited to begin the installation procedure 

and remove the protective film on the kitchen hood 

made of steel, until you make sure it is technically 

sound, connecting that to an electrical power net-

work and checking all its functions.

For that purpose, place the hood case (Fig.1, pos. 

2) to have the back side of the case, that should 

be retained against the wall, on the table or on the 

floor, and the mode selection switch of the hood, 

which is on the front panel, should face an inspect-

ing person.

After that connect the kitchen hood to the mains 

and check its function. Check that in all modes, 

and if it functions properly, you may begin the 

hood mounting. If not, contact the sales agency 

where you have purchased the hood, or warranty 

workshop.  

It is recommended to remove the protection film 

on the hoods made of stainless steel only upon 

completion of the installation procedure. 

Let us remind you that the hood mounting 

height above an electric stove shall be 65 cm at 

least, and 75 cm above a gas stove. 

Your hood can be installed in two methods. By at-

taching it on the wall or by attaching it to the wall 

drawer. If the hood is attached to a wall, then, as 

a rule, it is used for operation in the recirculation 

mode. In this case, it is necessary to install a coal 

filter on it, install the damper shown in Fig. 4, in 

the position of recirculation, close the holes at 

the bottom and at the top of the hood with a plug 

(included in the delivery set, the plugs are already 

installed in the right places).

When attaching the hood on the wall, the se-

quence of the installation procedure is as follows:

1.   Before drilling holes for dowels in the wall, 

markings must be made (Fig. 13).

2.   Drill two holes at the points marked on the 

wall. The depth of the holes must correspond 

to the length of the dowel.

3.   Install the two dowels in the holes drilled by 

you.

4.   Screw in two screws into the holes so that the 

distance between the wall and the head of the 

screw is 5 mm.

5.   Hang the hood at the reference points.

When mounting the hood on the wall drawer, the 

operations performed depend on the mode in 

which the hood will operate. If the hood is to op-

erate in the mode of exhausting air to the ventila-

tion shaft, then the installation operations are per-

formed in the following sequence (Fig. 14): 

1.   Make the layout of the drilling points from be-

low on the wall drawer for fixing screws and a 

flexible duct. Make the necessary holes.