KRONAsteel JESSICA, Application Sheet

11

EN  Application sheet

EN  Application sheet

KITCHEN HOODS

2.   Put one end of the flexible duct with a diameter 

of 120 mm (not included in the delivery set) on 

the adapter flange and secure it with a clamp 

(not included in the delivery set). Non-return 

valve prevents air from entering the ventilation 

shaft into the kitchen.

3.   Attach the hood with four screws to the wall 

drawer with the supplied fasteners, before 

that laying a flexible air duct through it. To re-

duce vibration and noise, it is desirable to lay 

insulating material between the hood and the 

drawer.

4.   Connect the other end of the flexible duct to 

the ventilation hole in the wall. The shorter and 

more straight the flex duct is, the higher the 

output and the less noise and vibration at the 

hood.

If the hood operates in recirculation mode, then 

the markings for the opening for the flexible duct 

should not be made. Install the coal filter on the 

hood, set the damper to the recirculation position 

and attach the hood to the drawer.

CONNECTION TO POWER SUPPLY

The kitchen hood is connected to the power net-

work with the voltage of 220-240V, 50 Hz.

The kitchen hood should be connected to a wall 

outlet with earthing to avoid electrocution.

It is absolutely prohibited to cut off the plug 

during kitchen hood installation.

The damaged electrical cord should be re-

placed by a qualified service specialist.

For additional protection of the kitchen hood from 

voltage drops in the network, connect it though an 

additional automatic switch 6A.

The kitchen hood is installed.

Switch it on and use it as you please.