KRONAsteel KAMILLA, Application Sheet

7

EN  Application sheet

EN  Application sheet

KITCHEN HOODS

Simultaneously with cleaning of the grease trap fil-

ter, clean all the accessible elements of the kitchen 

hood case from grease deposits.

To disconnect the aluminum filter (Fig. 11), press the 

spring lock on the filter and pull it and then press 

down to remove. When you remove the filter, do not 

apply the effort to the aluminum surface of the filter 

as it may lead to dents on its surface, affecting the 

external appearance of the filter.

Do not install the filter in the kitchen hood until it 

is completely dry. 

The filter is installed in the reverse order. Press the 

spring lock on the filter and put it in place, after 

which release the lock.

Replacement of Coal filters

Coal filters are installed on the protective grates of 

the exhaust motor box, located under the aluminum 

grease filter. To install the filter, it must be slightly 

tucked into the grate of the motor box and turn 

clockwise to fix it on the grate. To remove the char-

coal filter lightly press it to the motor box grate and 

rotate counterclockwise to release (Fig. 12).

Replacing the backlight lamps

To replace the backlight lamp (Fig. 13), it is neces-

sary to:

-   disconnect the hood from the power supply 

and find the wire of the burned lamp;

-   disconnect the power cord in the connector by 

pressing the two petals of the cover, remove the 

burned out lamp;

-   insert a new one in place of the burned-out 

lamp;

-   connect the lamp power wire in the connector;

-   connect the hood to the power supply and 

check the operation of the lamps.

Replacement of bulbs and filters is not 

included in the warranty service.

KITCHEN HOOD INSTALLATION  

INSTRUCTIONS

Only a specialist has the right to install and con-

nect the kitchen hood to the power supply.

Do not begin installation of the hood and do not 

remove the protective film from the stainless 

steel surfaces until you are sure of the technical 

serviceability of the hood by connecting it to the 

electrical network and checking all its functions.

To do this, open the package, remove the kitchen 

hood and place it on a flat surface so that the switch 

of operation mode are facing the inspector. Connect 

the hood to the power supply and check it. If the 

hood is working properly in all modes, proceed to 

the installation.  If not, contact the company - sup-

plier or warranty workshop. It is recommended to 

remove the protective film from the stainless steel 

surfaces only after the installation of the kitchen 

hood.

We remind you that the hood must be installed at 

least 65 cm above the electric stove and at least 

75 cm above the gas stove.

Attention!  It is recommended to use two per-

sons for installation of the kitchen hood. 

Before installing the kitchen hood, make sure that 

the wall on which the hood will be fixed is strong 

enough.  For the suspension of the kitchen hood 

and the decorative box lath use screws and dow-

els that correspond to the type of the wall in your 

kitchen (concrete, drywall, etc.).  If screws and dow-

els are included in the kit, make sure that they are 

suitable for the type of wall which the hood will be 

suspended on.

The installation of the kitchen hood is carried out in 

the following sequence.

Your model of the kitchen hood can be installed 

both to the wall and built into the hanging cabinet. 

Regardless of the installation it can be used both 

in the air recirculation mode and in the air exhaust 

mode to the ventilation shaft. 

When using the hood in recirculation mode, you 

should:

1.     Install carbon filters (available separately).