KRONAsteel KIRSA 500, Application Sheet

BG  Инструкция за инсталация и употреба

6

EN  Application sheet

KITCHEN HOODS

should be taken into account that the shorter 

and more straight (without bends) the flexible 

duct is, the higher the productivity is, there 

are less noise and less vibration in the hood. If 

the hood will operate in recirculation mode, a 

flexible duct is not used.

7. Make a marking for fixing the lath of the inner 

decorative casing (Figure 8.4).

8. Drill 2 holes with the diameter of the attached 

dowels.

9. Install 2 anchors in the drilled holes and tighten 

the bar to fix the decorative cover.

10. Attach the bar of the inner decorative duct to 

the required height, similar to the outer cover 
of case.

11.  Before  installing  decorative  cases,  connect 

the hood to the mains.

12.  Place  the  inside  of  the  casing  in  the  outer 

casing. Install the outer case on the hood.

13.  Lift  the  inner  part  of  the  casing  up  to  align 

the casing attachment points and the casing 
attachment plate and connect them. (Figure 
8.5).

CONNECTION TO POWER SUPPLY

The kitchen hood is connected to the power net-

work with the voltage of 220-240V, 50 Hz.

The kitchen hood should be connected to a wall 

outlet with earthing to avoid electrocution.

It is absolutely prohibited to cut off the plug 

during kitchen hood installation.

The damaged electrical cord should be re-

placed by a qualified service specialist.

For additional protection of the kitchen hood from 

voltage drops in the network, connect it though an 

additional automatic switch 6A.

The kitchen hood is installed.

Switch it on and use it as you please.