Settings
42
Pos : 23.10 /Ü berschriften/Ü berschriften 2/A-E/Einstell ung der Entl astungs federn @ 0\mod_1196666659447_78.doc @ 10133
9.2
Adjusting the Compensation Springs
Pos : 23.11 /BA/Ei nstellungen/M ähwer ke/Eas yCut/Bodendruc k/Bodendr uc k allgemeiner Text alle EC @ 0\mod_1196667271181_78.doc @ 10190
The ground pressure for the cutter bar is adjusted to local conditions by means of the
compensation springs. In order to protect the sward the load on the mowing spar must be
relieved so that it does not jump when mowing, yet does not leave any skid marks on the
ground.
Pos : 23.12 /BA/Ei nstellungen/M ähwer ke/Eas yCut/Bodendruc k/Bodendr uc k einstellen Bil d EC 28/32 @ 10\mod_1221738032880_78.doc @ 136927
EC-145-1
1
2
Fig. 18:
Pos : 23.13 /BA/Ei nstellungen/M ähwer ke/Eas yCut/Bodendruc k/Bodendr uc k einstellen T ext EC 28/32 28/32C V @ 10\mod_1221737841223_78.doc @ 136908
Note
Retaining chain shorter= reduced ground pressure
Retaining chain longer= increased ground pressure
If a telescope upper suspension arm is being used (optional)
The higher the compensation springs (1) are hooked into the perforated bar (2), the lower the
pressure on the ground in the front part of the cutter bar.
If the compensation springs are hooked in too high, the mowing unit will tip towards the
rear.
or:
The lower the compensation springs (1) are hooked into the perforated bar (2), the greater the
pressure on the ground in the front part of the cutter bar.
If the compensation springs are hooked in too low, the mowing unit will have too much
weight on the ground in front.
Pos : 23.14 /BA/-----Seitenumbruc h------ @ 0\mod_1196175311226_0.doc @ 4165