6
Initial operation
6.2
Setting the limit switch “Cross conveyor bottom”
40
EasyCut B 870 CV Collect
Original Operating Instructions 150000707_01_en
6.2
Setting the limit switch “Cross conveyor bottom”
KM000-141
The limit switch (1) must be set so that it has switched when the cross conveyor belt is in the
working position.
Checking
ü
The cross conveyor belt is in the working position.
ü
The machine is shut down and safeguarded,
.
Turn limit switch (1) until the stop (II) is reached.
Æ
When the limit switch (1) does not switch (click sound) when you continue to turn, the limit
switch is correctly set.
Æ
When the limit switch (1) switches (click sound) when you continue to turn, the limit switch
must be set.
Setting
ü
The cross conveyor belt is in the working position.
ü
The machine is shut down and safeguarded,
.
Loosen the screws (2).
Move the limit switch (1) in the oblong hole until it switches (click sound).
Tighten screws (2).
Check limit switch (1).
